NWSD Derringer/Kraut V3 FMM DSM Shift Servo The mounting holes for this

The mounting holes for this mount are designed to exactly match the frame rail of the Bouncing Betty

These sliders are designed to follow the lower frame rail of the GK01

This skid is design to use the Dlux NOD-2 Transmission for Straight Axles

This is a MWRM (Muscle Winch Rear Mount) for the Traxxas Stock Frame Rails

NWSD Derringer/Kraut V3 FMM DSM Shift Servo The mounting holes for thisThis is a Dual Servo Mount for the NWSD Derringer V3 chassis. The mounting holes for this mount are designed to exactly match the frame rail of the Derringer. This mount was designed to use a REEFS RC 99 Micro Servo Winch. Measurements for the mount are: Width 70mm Length 65mm Height 21mm Recommended Mounting Hardware: M3 X 8mm x 2 (Center 2 holes) M3 X 10mm x 4 (Front and Rear holes)