Gate Stop for Wood & Vinyl Gates C10846 The strike is 4" tall

The strike is 4" tall by 4-1/2"

made up of the hinge and a mounting plate

If three hinges are used the center hinge should be installed as close as possible to the top hinge for maximum support

2 x Plastic Dowels and Dowels Screws (pre-attached to the hinge) - Dowels are typically used on manufactured wood or MDF doors because they hold better than wood screws

Gate Stop for Wood & Vinyl Gates C10846 The strike is 4" tallThis gate stop acts to stop the gate properly and helps it from slamming shut. It is made for wood and vinyl gates. It features an integrated rubber buffer that softens the gate slam and reduces noise. Requires a minimum 7 16" gap between the gate and post. For gates taller than 4' use one two gate stops (one near the top and one near the bottom).