Extra Heavy Duty Roller Bearing Weld-On Hinge C10064 inside and out

inside and out

The center-to-center screw-hole dimension for the hinge wing that mounts on the face frame is 2-1/8"

There are two tabs on the square corner leaf used to align the hinge when installing

this hinge can be cut down using a hack saw or band saw

Extra Heavy Duty Roller Bearing Weld-On Hinge C10064 inside and outThis extra heavy duty weld on hinge is designed to attach to a flat gate frame and a round or flat gate post. It has a heavy duty 5 16" thick yoke, a grade 8 hardened steel pivot bolt, and three sealed roller bearings. Leaves a 2 3 4" gap between the gate and frame. The yoke has an oval slot which allows you to adjust the gap between the gate frame and post by 1 2". Two hinges are required for most applications. Safe to powder coat with hinges